Pre-Fab Manager Spool Filter
I just want to send in a suggestion to add to eVolve as I work 95% on spooling on the jobsite. As spools begin to populate, the time it takes to open the Pre-Fab Manager to see all generated spools, it take a long time to open. Might i suggest a way when you Click the Prefab Manager Button, a drop down prompt pops up asking if you would like to: 1. Load All Spools, 2. Load ONLY Spools that haven't been generated into sheets, 3. Load ONLY Spools that have been generated into sheets. I believe if this is implemented, it will cut back the time needed to load up all the spools.
Comments: 4
Oldest
•
Newest
•
Most likes
•
Fewest likes
-
17 May, '22
Joel F.Highlighted comment
This would help greatly! Not having to load all spools at once would be nice. -
06 Jul, '23
Ryan MergedOn our very large projects with hundreds of spools, it takes an incredible amount of time to open the prefab manager because it loads every spool. It would be nice if we could tell the manager to only open the most recent spools or only open spools based off of a Status.
-
19 Apr, '24
Adam System"Allow Prefab Manger to only load recent or defined set of spools" (suggested by <Hidden> on 2023-07-06), including upvotes (2) and comments (0), was merged into this suggestion.