Automate Sleeve Points
I'd like to be able to automate the placement of sleeve points as follows:
* Select a single service or multiple services to place points on.
* Select one or more elevations to place the points (Z direction):
** Top of a wall sleeve
** Bottom of a wall sleeve
** Center of a wall sleeve
* Select one or more location to place the points:
** Top of a floor sleeve
** Bottom of a floor sleeve
** Both ends of a wall sleeve
* Place the points on the center line of the sleeve (X and Y direction)
* Be able to export the following information into a CSV file:
** Service abbreviation
** Pipe size
** ITM description
Comments: 1
-
16 Apr
Adam AdminSince this is an older idea, the EVOLVE Sleeve tools should address what's being asked for here. See help doc below, if some additional requirements or limitations could be addressed, please post those as a new idea.
https://help-mechanical.evolvemep.com/sleeves/sleeve-settings